Les versions Beta se sont succédées à un rythme effréné ces dernières semaines, il était donc tout à fait logique de s’attendre à une version toute neuve ! Voilà qui est fait, avec AirOS V 5.2, destiné à tous les modules Ubiquiti disposant de la fonctionnalité Airmax : Bullet 2M & 5M, Nanostation 2M & 5M, Rocket 2M et 5M, etc.

Les changements récents sont :

V5.2-RC Changelog:

– Fix: Sometimes Auto ACK values gets too high
– Fix: Max power level for Australia
– GUI fix: Name -> Device Name
– GUI fix: Grammar error in warning message

V5.2-Beta8 Changelog:

– Fix: Speed test + AirMax PtP No Ack combination crashes AP
– Fix: Traffic Shaping is not functional except Soho Router mode
– Fix: Traffic Shaping Burst is for functional
– Fix: WPA security : Sometimes station is disassociated from AP
– Fix: Broadcast traffic is duplicated on AP-WDS
– Fix: NAT protocols state changes when changing security
– Fix: SNMP wrong OID type- Fix: Disallow port range as destination (to private subnet)
– Fix: Station can not connect to AP (MAC Locked) if it was connected to another AP with the same SSID
– Fix: Airmax PTMP ping loss issue after beta6
– Fix: AirMax: PTPNack AMQ/AMC fluctuation
– Fix: TX Power improvement for NanoBridge M5, AirGridM5, LocoM5, Bullet M2, Rocket M2, NanoStationM2, NanoBridge M2)
– Fix: AirMax: PTP and PTMP enhancements (latency)

– GUI: Problems with WPA PSK paraphrase: old value is displayed, new value is not saved
– GUI: Sometime Device name in not reported in Stations list
– GUI: Do not show clients as connected when authentication key is not valid
– GUI: Test mode. Timing is no so precise as stated in the warning message
– GUI: Need correctly display ACK/Distance when AirMax and PtPNoACK mode is enabled
– CCR: Report AirMax priority and AMQ/AMC in Station detail

—> Limitation from HW: MCS13 does not work with WEP/WPA/WPA2/WPA-TKIP/WPA2-TKIP security — MCS 13 removed from WEB UI

V5.2-Beta7:

– Improvement: Power control fix
– Improvement: AirMax: PTP and PTMP latency improvements
– Improvement: Speed test – resolves TX/RX difference
– Fix: SNMP reports incorrect wireless stats

– CCR: Speed test: Show total throughput (RX + TX)
– CCR: Make IP address in stations list as hyperlink
– CCR: GUI: Show/hide Traffic shaping configuration
– CCR: GUI: Add option to enable/disable NAT modules on router: SIP, PPTP, FTP, RTSP
– Fix: MCS1 is always reported in AP/Station statistics

Rendez-vous sur la page de téléchargement pour récupérer la version 5.2.

Be Sociable, Share!