AirOS 5.5RC disponible
La Release Candidate d’AirOS version 5.5 est disponible en téléchargement sur ce lien et son guide d’utilisation est ici.
Les mises à jour, in english :
- Improvement: AirMax performance in large PtMP networks
- Fix: DFS: Device hangs and reboots on radar pulse detection with frequency set to Auto and only one channel in Frequency List
- Fix: Bring back missing channels in EU countries (5.300MHz and 5.320MHz)
- Fix: Long association time in Long Range PtP Link mode
- Fix: Basic multicast rate for 2.4GHz products changed to the lowest rate (1Mbps)
- Fix: Exclude multicast/broadcast rates from RX data rate reporting
- Fix: Traffic bursting isn’t effective
- Fix: AirMax: Automatic distance calculation regression
- Fix: AirMax: Long Range PtP Link mode: Station stays in Station List even if powered off
- Fix: Change Default IPv6 behavior (disabled by default)
- Fix: Auto adjust distance issues in 3MHz channel width for M900 products
- Fix: Regression: IP Type P2P disappears in v5.5 firewall rules
- Fix: Traffic shaping rules duplicated after upgrade from v5.3.x to v5.5-beta12
- Fix: Ethernet Settings > Auto Negotiation option change after FW upgrade v5.3.x to v5.5-beta12
- Fix: Station falls into permanent scan state unexpectedly
- Fix: Station fails to authenticate (802.1x) to v5.3.x AP
- Fix: Port Forward rules disappear after upgrade from v5.2.1 to v5.5-beta12
- Fix: Impossible to disable/enable Device Discovery without reboot
- WEB UI: Add German translation
- WEB UI: Firewall table representation issue
- WEB UI: Port Forward table configuration issues
- WEB UI: NanoStationM900Loco antenna reporting issue in Main page
- WEB UI: WAN interface in Station/Router mode should be WLAN by default
- WEB UI: Don’t try to read DHCP leases file if it’s not present on device
- WEB UI: Change Wireless tab page title to « Wireless »
- WEB UI: Network > Interface settings – Management Interface reported twice
- WEB UI: Multicast routing fails if « Multicast Downstream » interface is not specified
- WEB UI: Show Horizontal/Vertical signal strength instead Chain0/Chain1 for products with integrated antennas
